Installing covers to rear parcel shelf

CAUTION

CAUTION

Make sure that the hinge is completely aligned with the pin. If the pin is forced into position, it may break.

Install the top tether anchor cover or key cylinder cover as follows:

1. With the pin on one end kept free of its hinge 1 , align the pin of the other end and slide it into the hinge 2 .

2. With the first pin in position 2 , align the

2. With the first pin in position 2 , align the second pin with its hinge slot 1 and push down on the cover to completely engage it. A snap sound will be heard.

3. Close the cover.

3. Close the cover.

    See also:

    Clearing the programmed information
    Individual buttons cannot be cleared. However, to clear all programming, press and hold the two outside buttons and release when the indicator light begins to flash (approximately 20 seconds). ...

    Change intervals
    The oil and oil filter change intervals for your engine are based on the use of the specified quality oils and filters. Using engine oil and filters that are not of the specified quality, or exc ...

    Tire Pressure Monitoring System (TPMS)
    This vehicle is equipped with the Tire Pressure Monitoring System (TPMS). It monitors tire pressure of all tires except the spare. When the low tire pressure warning light is lit, and the CHECK TI ...