Checking tire pressure

1. Remove the valve stem cap from the

1. Remove the valve stem cap from the tire.
2. Press the pressure gauge squarely onto the valve stem. Do not press too hard or force the valve stem sideways, or air will escape. If the hissing sound of air escaping from the tire is heard while checking the pressure, reposition the gauge to eliminate this leakage.
3. Remove the gauge.
4. Read the tire pressure on the gauge stem and compare to the specification shown on the Tire and Loading Information label.
5. Add air to the tire as needed. If too much air is added, press the core of the valve stem briefly with the tip of the gauge stem to release pressure. Recheck the pressure and add or release air as needed.
6. Install the valve stem cap.
7. Check the pressure of all other tires, including the spare.

Tire labeling

    See also:

    Continuously Variable Transmission (CVT)
    All-Wheel Drive (AWD) models: Do not tow an AWD vehicle with any of the wheels on the ground. Two-Wheel Drive (2WD) models: To tow a vehicle equipped with a Continuously Variable Transmission ( ...

    If your vehicle is stolen
    If your vehicle is stolen, you should change the codes of any non-rolling code device that has been programmed into HomeLink . Consult the Owner’s Manual of each device or call the manufacturer ...

    Styling
    The Sentra's tall stance and short hood and trunklid make the car look a bit stubby in profile. It's not nearly as sleek as the Civic, which is still futuristic looking even though it's been aroun ...