Heating

This mode is used to direct heated air to the foot outlets. Some air also flows from the defrost outlets and outboard vents.

1. Push the normal heating. button to the off position for normal heating.

2. Turn the air flow control dial to the position. position.

3. Turn the fan control dial to the desired position.

4. Turn the temperature control dial to the desired position between the middle and the hot position.

    See also:

    Programming HomeLink
    1. To begin, press and hold the two outer HomeLink buttons (to clear the memory) until the indicator light 1 blinks (after 20 seconds). Release both buttons. 2. Position the end of the hand-held ...

    Exterior front
    Exterior front 1. Engine hood. 2. Windshield wiper and washer switch. 3. Windshield. 4. Moonroof (if so equipped). 5. Power windows. 6. Door locks, Nissan Intelligent Key, keys, request butt ...

    Using the panic alarm
    Using the panic alarm If you are near your vehicle and feel threatened, you may activate the panic alarm to call attention by pressing and holding the button on the Intelligent Key for longe ...