Automatic moonroof
The moonroof only operates when the ignition switch is in the ON position.
The automatic moonroof is operational for about 45 seconds, even if the ignition switch is turned to the OFF position. If the driver’s door or the passenger’s door is opened during this period of about 45 seconds, power to the moonroof is canceled.
Sunshade
The sunshade will open automatically when the moonroof is opened. However, it must be closed manually.
Sliding the moonroof
To fully open or close the moonroof, push the switch toward 1 or 2 and release it; it need not be held. The roof will automatically open or close all the way. To stop the roof, push the switch in any direction while it is opening or closing.
Tilting the moonroof
To tilt up, first close the moonroof by pushing the switch toward 2 . Push the switch toward 2 again and release it; it need not be held. To tilt down the moonroof, push the switch toward 1 .
Auto reverse function
There are some small distances immediately before the closed position which cannot be detected. Make sure that all passengers have their hands, etc., inside the vehicle before closing the moonroof.
If the control unit detects something caught in the moonroof when it is closing, the moonroof will be immediately opened.
The auto reverse function can be activated when the moonroof is closed by automatic operation when the ignition switch is in the ON position or for about 45 seconds after the ignition switch is turned to the OFF position.
If the moonroof cannot be closed automatically when the auto reverse function activates due to a malfunction, push and hold the switch toward 2 .
Depending on the environment or driving conditions, the auto reverse function may be activated if an impact or load similar to something being caught in the moonroof occurs.
If the moonroof does not operate
If the moonroof does not operate properly, perform the following procedure to initialize the moonroof operation system.
1. If the moonroof is open, close it fully by
repeatedly pushing the switch toward
2 .
2. Push and hold the switch toward 2 to tilt the moonroof up.
3. Release the moonroof switch after the moonroof moves slightly up and down.
4. Push and hold the switch toward
1 to
fully tilt the moonroof down.
5. Check if the moonroof switch operates normally.
If the moonroof does not operate properly after performing the procedure above, have your vehicle checked by a NISSAN dealer.
See also:
Parking brake reminder chime
The parking brake reminder chime will sound if
the vehicle is driven at more than 4 MPH (7
km/h) with the parking brake applied. Stop the
vehicle and release the parking brake. ...
Valet hand-off
When you have to leave a key with a valet, give
them the Intelligent Key itself and keep the mechanical
key with you to protect your belongings.
To prevent the glove box and the trunk from being
o ...
Parking brake break-in
Break-in the parking brake shoes whenever the
stopping effect of the parking brake is weakened
or whenever the parking brake shoes and/or
drum/rotors are replaced, in order to assure the
best brak ...