Installing front license plate
Use the following steps to mount the front license plate:
(1) Make holes on the plastic finisher at the location mark (small dimple) using a 0.31 in (8 mm) drill. Apply light pressure to the drill.
Install the license plate holder using the two screws provided with the holder.
(2)- Mount the license plate using two M6- 14mm bolts.
License plate bolt tightening torque:
3.8 - 4.7 ft-lb (5.10 - 6.37 N·m)
See also:
Rapid air pressure loss
Rapid air pressure loss or a “blow-out” can occur
if the tire is punctured or is damaged due to
hitting a curb or pothole. Rapid air pressure loss
can also be caused by driving on under-infl ...
Operating tips
- When the selector lever is shifted to the R
(Reverse) position, the monitor screen automatically
changes to the RearView Monitor
mode. However, the radio can be heard.
- It may take some time ...
Tire rotation
NISSAN recommends rotating the tires
every 7,500 miles (12,000 km).
See “Flat tire” in the “In case of emergency”
section of this manual for tire replacing
procedures.
As soon as possib ...