Drive belt

MR20DE model
MR20DE model

1. Automatic tensioner
2. Generator
3. Water pump
4. Air conditioner compressor (with A/C) or Idler pulley (without A/C)
5. Crankshaft pulley

QR25DE model
QR25DE model

1. Crankshaft pulley
2. Idler Pulley
3. Automatic tensioner
4. Water pump
5. Generator
6. Air conditioner compressor

Be sure the ignition switch is in the OFF or

Be sure the ignition switch is in the OFF or LOCK position before servicing drive belt.

The engine could rotate unexpectedly.

1. Visually inspect the belt for signs of unusual wear, cuts, or fraying. If the belt is in poor condition, have it replaced or adjusted by a NISSAN dealer.

2. Have the belt checked regularly for condition.

    See also:

    LATCH (Lower Anchors and Tethers for CHildren) System
    LATCH system lower anchor locations Your vehicle is equipped with special anchor points that are used with LATCH (Lower Anchors and Tethers for CHildren) system compatible child restraints. T ...

    Heater operation
    Heating This mode is used to direct heated air to the foot outlets. Some air also flows from the defrost outlets and the side vent outlets. 1. Press the button to the OFF position for normal h ...

    Universal Serial Bus (USB) memory (if so equipped)
    This system supports various USB memory sticks, USB hard drives and iPod players. There are some USB devices which may not be supported with this system. ● Make sure that the USB device is c ...