ON position
When the switch is in the ON position 1 , the ceiling light will illuminate.
See also:
Programming HomeLink
1. To begin, press and hold the two outer
HomeLink buttons (to clear the memory)
until the indicator light (1) blinks (after 20
seconds). Release both buttons.
2. Position the end of the hand ...
Important information about this manual
You will see various symbols in this manual. They
are used in the following ways:
This is used to indicate the presence of
a hazard that could cause death or
serious personal injury. To avo ...
All-Wheel Drive (AWD) lock switch operations
The AWD LOCK switch located on the lower
side of the instrument panel. This switch is used
to select the AUTO or LOCK mode depending
on the driving conditions.
Each time you push the lower pa ...
