Cruise control operations

1. ACCEL/RES switch

1. ACCEL/RES switch
2. COAST/SET switch
3. CANCEL switch
4. MAIN (ON·OFF) switch

The cruise control allows driving at a speed between 25 to 89 MPH (40 to 144 km/h) without keeping your foot on the accelerator pedal.

To turn on the cruise control, push the MAIN switch on. The CRUISE indicator on the vehicle information display will illuminate.

To set cruising speed, accelerate the vehicle to the desired speed, push the COAST/SET switch and release it. (The SET indicator light on the vehicle information display will illuminate.) Take your foot off the accelerator pedal. Your vehicle will maintain the set speed.

- To pass another vehicle, depress the accelerator pedal. When you release the pedal, the vehicle will return to the previously set speed.

- The vehicle may not maintain the set speed on winding or hilly roads. If this happens, drive without the cruise control.

To cancel the preset speed, use one of the following methods:
- Push the CANCEL switch. The SET indicator on the vehicle information display will turn off.

- Tap the brake pedal. The SET indicator on the vehicle information display will turn off.

- Turn the MAIN switch off. Both the CRUISE and SET indicator on the vehicle information display will turn off.

— If you depress the brake pedal while pushing the ACCEL/RES or COAST/ SET switch and reset at the cruising speed, the cruise control will disengage.

Turn the MAIN switch off once and then turn it on again.

— The cruise control will automatically cancel if the vehicle slows more than 8 MPH (12 km/h) below the set speed.

— If you move the selector lever to the N (Neutral) position, the cruise control will be canceled.

To reset at a faster cruising speed, use one of the following methods:
- Depress the accelerator pedal. When the vehicle attains the desired speed, push and release the COAST/SET switch.

- Push and hold the ACCEL/RES switch.

When the vehicle attains the desired speed, release the switch.

- Push, then quickly release the ACCEL/RES switch. Each time you do this, the set speed will increase by about 1 MPH (1.6 km/h).

To reset at a slower cruising speed, use one of the following methods:
- Lightly tap the brake pedal. When the vehicle attains the desired speed, push the COAST/SET switch and release it.

- Push and hold the COAST/SET switch.

Release the switch when the vehicle slows down to the desired speed.

- Push, then quickly release the COAST/SET switch. Each time you do this, the set speed will decrease by about 1 MPH (1.6 km/h).

To resume the preset speed, push and release the ACCEL/RES switch. The vehicle will resume the last set cruising speed when the vehicle speed is over 25 MPH (40 km/h).

    See also:

    Most common factors contributing to vehicle corrosion
    - The accumulation of moisture-retaining dirt and debris in body panel sections, cavities, and other areas. - Damage to paint and other protective coatings caused by gravel and stone chips or ...

    Heated seats (if so equipped)
    Do not use or allow occupants to use the seat heater if you or the occupants cannot monitor elevated seat temperatures or have an inability to feel pain in those body parts in contact with ...

    Wheels and tires
    If you have a flat tire, see “Flat tire” in the “6. In case of emergency” section. ...