To protect your vehicle from corrosion

- Wash and wax your vehicle often to keep the vehicle clean.

- Always check for minor damage to the paint and repair it as soon as possible.

- Keep drain holes at the bottom of the doors open to avoid water accumulation.

- Check the underbody for accumulation of sand, dirt or salt. If present, wash with water as soon as possible.

- NEVER remove dirt, sand or other

- NEVER remove dirt, sand or other debris from the passenger compartment by washing it out with a hose.

Remove dirt with a vacuum cleaner.

- Never allow water or other liquids to come in contact with electronic components inside the vehicle as this may damage them.

Chemicals used for road surface deicing are extremely corrosive. They accelerate corrosion and deterioration of underbody components such as the exhaust system, fuel and brake lines, brake cables, floor pan and fenders.

In winter, the underbody must be cleaned periodically.

For additional protection against rust and corrosion, which may be required in some areas, consult a NISSAN dealer.

    See also:

    Push-button ignition switch positions
    LOCK (Normal parking position): The ignition switch can only be locked in this position. The ignition switch will be unlocked when it is pushed to the ACC position while carrying the Intelligent ...

    Troubleshooting guide
    Verify the location of all Intelligent Keys that are programmed for the vehicle. If another Intelligent Key is in range or inside the vehicle, the vehicle system may respond differently than expect ...

    Dehumidified heating
    This mode is used to heat and dehumidify the air. 1. Push the button to the off position. 2. Turn the air flow control dial to the position. 3. Turn the fan control dial to the desired positio ...