Vehicle set-up

1. Park the vehicle on a level surface and apply the parking brake.

2. Start the engine and let it idle until it reaches operating temperature.

3. Turn the engine off and wait more than 10 minutes.

4. Raise and support the vehicle using a suitable floor jack and safety jack stands.

- Place the safety jack stands under the vehicle jack-up points.

- A suitable adapter should be attached to the jack stand saddle.

Make sure the correct lifting and support

Make sure the correct lifting and support points are used to avoid vehicle damage.

    See also:

    Backing up on a steep uphill
    Backing up on a steep uphill When backing up the vehicle up a hill, the distance guide lines and the vehicle width guide lines are shown closer than the actual distance. For example, the displ ...

    EXTERIOR
    From the windshield back, the Murano CrossCabriolet is every bit a sexy convertible with a tail end that's reminiscent of its near relative, the Nissan 370Z. However, most people I polled weren't ...

    Variable voltage control system
    CAUTION: - Do not ground accessories directly to the battery terminal. Doing so will bypass the variable voltage control system and the vehicle battery may not charge completely. - Use ele ...