Drive belts

1. Alternator

1. Alternator
2. Water pump
3. Drive belt auto-tensioner
4. Crankshaft pulley
5. Air conditioner compressor

Be sure the ignition switch is in the OFF

Be sure the ignition switch is in the OFF or LOCK position before servicing drive belts. The engine could rotate unexpectedly.

1. Visually inspect each belt for signs of unusual wear, cuts, fraying or looseness. If the belt is in poor condition or loose, have it replaced or adjusted by a NISSAN dealer.

2. Have the belts checked regularly for condition.

    See also:

    Most common factors contributing to vehicle corrosion
    -The accumulation of moisture-retaining dirt and debris in body panel sections, cavities, and other areas. - Damage to paint and other protective coatings caused by gravel and stone chips or ...

    Maximum trailer loads
    Never allow the total trailer load to exceed the value specified in the “Towing Load/Specification” chart. The total trailer load equals trailer weight plus its cargo weight. - When towing ...

    Initialization
    When the ignition switch is placed in the ON position, NISSAN Voice Recognition is initialized, which takes a few seconds. If the button is pushed before the initialization completes, the sys ...