Capacities and recommended fuel/lubricants

1: For additional information, see “Engine oil” in the “8. Maintenance and do-it-yourself” section for changing engine oil.
2: For additional information, see “Engine oil and oil filter recommendation” later in this section.
3: Use only Genuine NISSAN CVT Fluid NS-2. Using transmission fluid other than Genuine NISSAN CVT Fluid NS-2 will damage the CVT, which is not covered by the NISSAN new vehicle limited warranty.
4: For hot climates, viscosity SAE 90 is suitable for ambient temperatures above 328F (08C).
5: Available in mainland U.S.A. through a NISSAN dealer.
6: For additional information, see “Vehicle identification” later in this section for air conditioner specification label.
See also:
Environmental factors influence the rate of corrosion
Moisture
Accumulation of sand, dirt and water on the vehicle
body underside can accelerate corrosion.
Wet floor coverings will not dry completely inside
the vehicle and should be removed for dry ...
Tongue load
Keep the tongue load between 10 - 15 percent of
the total trailer load or use the trailer tongue load
specified by the trailer manufacturer. The tongue
load must be within the maximum tongue load ...
Difference between predicted and actual distances
The distance guide line and the vehicle width
guide line should be used as a reference only
when the vehicle is on a level, paved surface. The
distance viewed on the monitor is for reference
o ...
