Technical and consumer information

See also:

Installing front license plate
Use the following steps to mount the front license plate: (1) Make holes on the plastic finisher at the location mark (small dimple) using a 0.31 in (8 mm) drill. Apply light pressure to the ...

Jump starting
If jump starting is necessary, see “Jump starting” in the “In case of emergency” section of this manual. If the engine does not start by jump starting, the battery may have to be replaced. ...

BluetoothT Hands-Free Phone System without Navigation System (if so equipped)
WARNING: - Use a phone after stopping your vehicle in a safe location. If you have to use a phone while driving, exercise extreme caution at all times so full attention may be given to vehicl ...