Outside mirrors
The outside mirror remote control will operate only when the ignition switch is in the ACC or ON position.
Move the small switch (1) to select the right or left mirror. Adjust each mirror to the desired position using the large switch (2).
WARNING:
- Objects viewed in the outside mirror on the passenger side are closer than they appear. Be careful when moving to the right. Using only this mirror could cause an accident. Use the inside mirror or glance over your shoulder to properly judge distances to other objects.
- Do not adjust the mirrors while driving.
You could lose control of your vehicle and cause an accident.
Automatic anti-glare outside mirrors (if so equipped)
The drivers outside mirror will automatically dim during nighttime conditions to reduce the glare from the headlights of trailing vehicles. The automatic anti-glare feature operates only when the ignition switch is placed in the ON position.
The automatic anti-glare feature will be on when starting the vehicle. The indicator light on the automatic anti-glare rearview mirror will illuminate when the automatic anti-glare feature is on.
To turn off the automatic anti-glare feature, press:
- the button on rearview
mirror without
compass (Type B).
- the button on rearview
mirror with
compass (Type C).
The indicator light will turn off.
To turn on the automatic anti-glare feature again, press:
- the button on rearview
mirror without
compass (Type B).
- the button on rearview
mirror
equipped with compass (Type C).
The indicator light will turn on.
For information on the automatic anti-glare rearview mirror, see Automatic anti-glare rearview mirror in this section.
Reverse tilt-down feature (if so equipped)
The reverse tilt-down feature will turn both outside mirror surfaces downward to provide better rear visibility close to the vehicle when the small switch is in either the L or R position.
NOTE:
If the outside mirror control switch is in the neutral position, neither mirror will turn downward when the shift selector is moved to R (Reverse).
Move the shift selector to R (Reverse). Both mirrors will turn downward.
The mirror surfaces will return to their original position when any of the following have occurred:
- The shift selector is moved to any position other than R (Reverse).
- The outside mirror control switch is set to the neutral or center position.
- The ignition switch is placed in the OFF position.
Heated mirrors (if so equipped)
The electric control type outside mirrors (if so equipped) can be heated to defrost, defog, or de-ice for improved visibility. Push the rear window defogger switch to activate the heating function. Push the switch again to deactivate, or the heating function will automatically turn off after approximately 15 minutes.
Foldable outside mirrors
Pull the outside mirror toward the door to fold it.
See also:
Locking with inside lock knob
Inside lock
To lock the door without the key, move the inside
lock knob to the lock position 1 , then close the
door.
To unlock the door without the key, move the
inside lock knob to the unlock ...
Manual operation
The manual mode can be used to control the
heater and air conditioner to your desired
settings.
To turn off the heater and air conditioner, turn the
fan control dial to the OFF position.
Fan s ...
Locking doors
Locking doors
1. Move the shift selector to the P (Park) position,
place the ignition switch in the LOCK
position and make sure you carry the Intelligent
Key with you.
2. Close all doors.
3. Pus ...