Windshield wiper blades. Replacing
Replace the wiper blades if they are worn.
1. Lift the wiper arm away from the windshield.
2. Push the release tab, then move the wiper blade down the wiper arm to remove.
3. Remove the wiper blade.
4. Insert the new wiper blade onto the wiper arm until it clicks into place.
CAUTION:
- After wiper blade replacement, return the wiper arm to its original position;
otherwise it may be damaged when the hood is opened.
- Make sure the wiper blades contact the glass; otherwise the arms may be damaged from wind pressure.
Be careful not to let anything get into the washer nozzle (A) . This may cause clogging or improper windshield washer operation. If something gets into the nozzle, remove it with a needle or small pin (B).
See also:
If your vehicle is stolen
If your vehicle is stolen, you should change the
codes of any non-rolling code device that has
been programmed into HomeLink. Consult the
Owners Manual of each device or call the manufacturer
...
Ending a call
To finish the call, perform one of the following
procedures:
● Select the “Hang up” key on the “Call in
Progress” display.
● Push the switch on the
steering
wheel. ...
Operating the HomeLink universal
transceiver
The HomeLink Universal Transceiver (once programmed)
may now be used to activate the garage
door, etc. To operate, simply press the appropriate
programmed HomeLink Universal
Transceiver button. Th ...