Hazard warning flasher switch

Push the switch on to warn other drivers when you must stop or park under emergency conditions. All turn signal lights flash.
WARNING
● If stopping for an emergency, be sure to
move the vehicle well off the road.
● Do not use the hazard warning flashers
while moving on the highway unless
unusual circumstances force you to
drive so slowly that your vehicle might
become a hazard to other traffic.
● Turn signals do not work when the hazard
warning flasher lights are on.
The flashers will operate with the ignition switch placed in any position.
Some state laws may prohibit the use of the hazard warning flasher switch while driving.
See also:
IC Regulatory information
- Operation is subject to the following two
conditions: (1) this device may not cause
interference, and (2) this device must accept
any interference, including interference that
may cause unde ...
Programming HomeLink for Canadian customers
Prior to 1992, D.O.C. regulations required handheld
transmitters to stop transmitting after 2 seconds.
To program your hand-held transmitter to
HomeLink, continue to press and hold the
HomeLink ...
Hood
Hood
1. Pull the hood lock release handle 1 located
below the instrument panel until the hood
springs up slightly.
2. Locate the lever 2 in between the hood and
grille and push the lever sid ...
