Vehicle Dynamic Control (VDC) off switch

Nissan Altima / Nissan Altima Owners Manual / Instruments and controls / Vehicle Dynamic Control (VDC) off switch

The vehicle should be driven with the Vehicle

The vehicle should be driven with the Vehicle Dynamic Control (VDC) system on for most driving conditions.

If the vehicle is stuck in mud or snow, the VDC system reduces the engine output to reduce wheel spin. The engine speed will be reduced even if the accelerator is depressed to the floor. If maximum engine power is needed to free a stuck vehicle, turn the VDC system off.

To turn off the VDC system, push the VDC OFF switch. The Push the VDC OFF switch again or restart the indicator will come on.

Push the VDC OFF switch again or restart the engine to turn on the system. See “Vehicle Dynamic Control (VDC) system” in the “Starting and driving” section.

    See also:

    Fastening the seat belts
    1. Adjust the seat. See “Seats” earlier in this section. 2 Slowly pull the seat belt out of the retractor and insert the tongue into the buckle until you hear and feel the latch engage. & ...

    Vacuum assisted brakes
    The brake booster aids braking by using engine vacuum. If the engine stops, you can stop the vehicle by depressing the brake pedal. However, greater foot pressure on the brake pedal will be re ...

    Pulling a stuck vehicle
    Front Do not use the tie down hooks for towing or vehicle recovery. Front: Securely install the recovery hook 1 (stored in the luggage room) as illustrated. Make sure that the hook is proper ...