Removing covers from rear parcel shelf

Remove the top tether anchor cover or key cylinder

Remove the top tether anchor cover or key cylinder cover as follows:

1. Lift the cover to the full open position.

2. Rotate the cover in the direction shown,

2. Rotate the cover in the direction shown, disengaging the hinge at 1 and slide the second pin from the hinge 2 and remove the cover.

    See also:

    High fluid temperature protection mode
    This transmission has a high fluid temperature protection mode. If the fluid temperature becomes too high (for example, when climbing steep grades in high temperature with heavy loads, such as ...

    Emission control information label
    The emission control information label is attached to the underside of the hood as shown. ...

    Programming HomeLink
    1. To begin, press and hold the two outer HomeLink buttons (to clear the memory) until the indicator light 1 blinks (after 20 seconds). Release both buttons. 2. Position the end of the hand-held ...