Operating tips

● Say a command after the tone. Voice commands cannot be accepted when the icon is ● Commands that are available are always.

● Commands that are available are always shown on the display and spoken through voice menu prompts. Commands other than those that are displayed are not accepted. Please follow the prompts given by the system.

● If the command is not recognized, the system repeats the announcement. Repeat the command in a clear voice.

● Press the steering switch on the steering wheel to return to the previous screen.

● If you want to cancel the command, press and hold the “Voice cancelled” will be announced. switch. The message, “Voice cancelled” will be announced.

● If you want to adjust the volume of the system feedback, push the volume control switch on the steering wheel or use the audio system volume knob while the system is making an announcement.

    See also:

    Car Not Go
    The Cube's four-cylinder engine offers up modest power at best, and it emits a muffled roar when pushed hard. There's little fun to be had at higher revs, which might have sufficed a decade ago. T ...

    RearView Monitor (if so equipped)
    When the shift selector is shifted into the R (Reverse) position, the monitor display shows the view to the rear of the vehicle. The system is designed as an aid to the driver in detecting larg ...

    Clearing the programmed information
    Individual buttons cannot be cleared, however to clear all programming, push and hold the two outside buttons and release when the indicator light begins to flash (in approximately 20 seconds) ...