FM-AM-SAT(if so equipped) radio operation
radio (FM/AM) band select:
Pushing the radio band select button will
change the band as follows:
AM FM1
FM2
AM
radio (SAT) band select (models with satellite radio):
Pushing the XM band select button will change
the band as follows:
XM1 XM2
XM3
XM1
When the XM band select button is pushed
while the ignition switch is in the ACC or ON
position, the radio will come on at the channel
last played.
The last channel played will also come on when the PWR button is pushed to ON.
The satellite radio is not available in Alaska, Hawaii and Guam.
If another audio source is playing when the radio band select button is turned to ON, the audio source will automatically be turned off and the last radio channel played will come on.
When the stereo broadcast signal is weak, the radio will automatically change from stereo to monaural reception.
TUNE (Tuning):
- For AM and FM radio
Turn the radio TUNE·SCROLL control knob
for manual tuning.
- For XM Satellite Radio
Turn the radio TUNE·SCROLL control knob
to seek channels from all of the categories
when any category is not selected.
SEEK tuning/CAT (category) (models with satellite radio):
- For AM and FM radio
Push the SEEK button or
to tune
from low to high or high to low frequencies
and to stop at the next broadcasting station.
- For XM Satellite Radio
Push the SEEK button or
to tune
to the first channel of the next or previous
category.
SCAN tuning:
Push the Radio SCAN tuning button to tune from low to high frequencies and stop at each broadcasting station/channel for 5 seconds.
Pushing the button again during this 5 seconds period will stop SCAN tuning and the radio will remain tuned to that station/channel.
If the Radio SCAN tuning button is not pushed within 5 seconds, SCAN tuning moves to the next station/channel.
1 to 6 Station memory operations:
12 stations/channels can be set for the FM band (6 each for FM1 and FM2), 12 for XM radio (6 each for XM1 and XM2) (if so equipped) and 6 stations can be set for the AM band.
1. Choose the radio band using the radio band select button.
2. Tune to the desired station/channel using the SEEK·CAT (models with satellite radio), SEEK·TRACK (models without satellite radio), SCAN button or the radio TUNE·SCROLL control knob.
3. Push and hold the desired station preset button 1 to 6 until the radio mutes.
4. The station indicator will then come on and the sound will resume. Memorizing is now complete.
5. Other buttons can be set in the same manner.
If the battery cable is disconnected, or if the fuse opens, the radio memory will be erased. In that case, reset the desired stations/channels.
See also:
Vehicle identification number (VIN) plate
The vehicle identification number (VIN) plate is
attached as shown. This number is the identification
for your vehicle and is used in the vehicle
registration. ...
Cruise control operations
1. ACCEL/RES switch
2. COAST/SET switch
3. CANCEL switch
4. MAIN (ON·OFF) switch
The cruise control allows driving at a speed
between 25 to 89 MPH (40 to 144 km/h)
without keeping your f ...
Rapid air pressure loss
Rapid air pressure loss or a “blow-out” can occur
if the tire is punctured or is damaged due to
hitting a curb or pothole. Rapid air pressure loss
can also be caused by driving on under-infl ...