Nissan Versa: Technical and consumer information for your Nissan Versa - Vehicle identification
Vehicle Identification Number (VIN) plate

The Vehicle Identification Number (VIN) plate is securely attached to your Nissan Versa as illustrated. This unique serial number serves as the primary official identification for your vehicle and is universally used for all vehicle registration, titling, and insurance documents.
Vehicle identification number (chassis number)

The secondary vehicle identification chassis number is permanently stamped and located on your Nissan Versa as shown in the diagram.
Engine serial number

1.6L 4 cylinder (HR16DE engine model)
The unique engine serial number is permanently stamped directly onto the engine block of your Nissan Versa as shown.
F.M.V.S.S./C.M.V.S.S. certification label

The official Federal/Canadian Motor Vehicle Safety Standard (F.M.V.S.S./C.M.V.S.S.) certification label is securely affixed to your Nissan Versa as shown. This important regulatory label contains valuable, legally required vehicle data, such as: the Gross Vehicle Weight Rating (GVWR), Gross Axle Weight Ratings (GAWR), the exact month and year of vehicle manufacture, and the Vehicle Identification Number (VIN). Be sure to review this information carefully.
Emission control information label

The official emission control information label for your Nissan Versa is permanently attached to the underside of the hood as illustrated.
Tire and Loading Information label

The recommended cold tire inflation pressures and maximum load limits are clearly displayed on the Tire and Loading Information label. This crucial safety label is located on your Nissan Versa as shown.
Air conditioner specification label

The climate control air conditioner specification label is affixed to the underside of the hood of your Nissan Versa as shown.

Air Conditioner Specification Label Symbols
Installing front license plate

To properly mount the front license plate on your Nissan Versa, securely attach the license plate mounting bracket directly to the front bumper fascia at the designated factory location marks (indicated by small dimples) using the two provided screws labeled A.