Installing top tether strap

First, secure the child restraint with the LATCH

First, secure the child restraint with the LATCH lower anchors (rear outboard seat positions only) or the seat belt, as applicable.

1. Flip up the anchor cover 1 from the anchor point which is located directly behind the child seat.

2. If necessary, raise or remove the head restraint to position the top tether strap over the top of the seatback. If the head restraint is removed, store it in a secure place. Be sure to reinstall the head restraint when the child restraint is removed. See “Head restraints” in this section for head restraint adjustment, removal and installation information.

3. Secure the tether strap to the tether anchor point on the rear parcel shelf.

4. Refer to the appropriate child restraint installation procedure steps in this section before tightening the tether strap.

If you have any questions when installing a top tether strap, consult your NISSAN dealer for details.

    See also:

    Volume control switch
    Push the volume control switch up or down to increase or decrease the volume. Tuning Memory change (radio): Push the tuning switch ( or ) for less than 1.5 seconds to change presets. Seek t ...

    Horn
    Horn To sound the horn, push the center pad area of the steering wheel. Do not disassemble the horn. Doing so could affect proper operation of the supplemental front air bag system. Tam ...

    California proposition 65 warning
    Engine exhaust, some of its constituents, and certain vehicle components contain or emit chemicals known to the State of California to cause cancer and birth defects or other reproductive ...