Air cleaner

MR20DE
MR20DE

The air cleaner filter should not be cleaned and reused. Replace it according to the maintenance log shown in the “NISSAN Service and Maintenance Guide.” To remove the air cleaner filter.

1. Unlatch the clips and move the air cleaner cover upward.

2. Remove the air cleaner filter.

● For the MR20DE, release the 2 retaining clips A and pull the unit upward.

● For the QR25DE, push the tabs A and pull the unit upward B .

QR25DE
QR25DE

3. Wipe the inside of the air cleaner filter housing and the cover with a damp cloth.

NOTE:
After installing a new air cleaner, make sure the air cleaner cover is seated in the housing and latch the clips.

● Operating the engine with the air
● Operating the engine with the air cleaner removed can cause you or others to be burned. The air cleaner not only cleans the air, it stops the flame if the engine backfires. If it isn’t there, and the engine backfires, you could be burned. Do not drive with the air cleaner removed, and be careful when working on the engine with the air cleaner removed.

● Never pour fuel into the throttle body or attempt to start the engine with the air cleaner removed. Doing so could result in serious injury.

See also:

Vehicle Dynamic Control (VDC) off switch
The vehicle should be driven with the Vehicle Dynamic Control (VDC) system on for most driving conditions. If the vehicle is stuck in mud or snow, the VDC system reduces the engine output to red ...

Precautions on Supplemental Restraint System
This Supplemental Restraint System (SRS) section contains important information concerning the following systems: - Driver and passenger supplemental frontimpact air bag (NISSAN Advanced Air B ...

Engine block heater (if so equipped)
Engine block heaters are used to assist in cold temperature starting. The engine block heater should be used when the outside temperature is 208F (−78C) or lower. To use the engine block h ...