Tire rotation

Tire rotation
Tire rotation

NISSAN recommends rotating the tires every 7,500 miles (12,000 km).

See “Flat tire” in the “In case of emergency” section of this manual for tire replacing procedures.

As soon as possible, tighten the wheel nuts to the specified torque with a torque wrench.

Wheel nut tightening torque.

83 ft-lb (113 N·m)

The wheel nuts must be kept tightened to specifications at all times. It is recommended that wheel nuts be tightened to specification at each tire rotation interval.

● After rotating the tires, check and

● After rotating the tires, check and adjust the tire pressure.

● Retighten the wheel nuts when the vehicle has been driven for 600 miles (1,000 km) (also in cases of a flat tire, etc.).

● Do not include the spare tire in the tire rotation.

● For additional information regarding tires, refer to “Important Tire Safety Information” (US) or “Tire Safety Information” (Canada) in the Warranty Information Booklet.

1. Wear indicator

1. Wear indicator
2. Location mark

Tire wear and damage

● Tires should be periodically inspected

● Tires should be periodically inspected for wear, cracking, bulging or objects caught in the tread.

If excessive wear, cracks, bulging or deep cuts are found, the tire(s) should be replaced.

● The original tires have built-in tread wear indicators. When the wear indicators are visible, the tire(s) should be replaced.

● Tires degrade with age and use.

Have tires, including the spare, over 6 years old checked by a qualified technician because some tire damage may not be obvious.

Replace the tires as necessary to prevent tire failure and possible personal injury.

● Improper service of the spare tire may result in serious personal injury.

If it is necessary to repair the spare tire, contact a NISSAN dealer.

● For additional information regarding tires, refer to “Important Tire Safety Information” (US) or “Tire Safety Information” (Canada) in the Warranty Information Booklet.

    See also:

    Rearview mirror (if so equipped)
    The night position 1 reduces glare from the headlights of vehicles behind you at night. Use the day position 2 when driving in daylight hours. WARNING Use the night position only when necessary ...

    If the windows do not close automatically
    If the power window automatic function (closing only) does not operate properly, perform the following procedure to initialize the power window system. 1. Turn the ignition switch to the ON pos ...

    Towing your vehicle
    When towing your vehicle, all State (Provincial in Canada) and local regulations for towing must be followed. Incorrect towing equipment could damage your vehicle. Towing instructions are avai ...