Automatic moonroof
The moonroof only operates when the ignition switch is in the ON position.
The automatic moonroof is operational for about 45 seconds, even if the ignition switch is turned to the OFF position. If the driver’s door or the passenger’s door is opened during this period of about 45 seconds, power to the moonroof is canceled.
Sunshade
The sunshade will open automatically when the moonroof is opened. However, it must be closed manually.
Sliding the moonroof
To fully open or close the moonroof, push the
switch toward 1 or
2 and release
it; it need not be held. The roof will automatically
open or close all the way. To stop the roof, push
the switch in any direction while it is opening or
closing.
Tilting the moonroof
To tilt up, first close the moonroof by pushing the
switch toward 2 . Push the switch toward
2 again and
release it; it need not be
held. To tilt down the moonroof, push the switch
toward
1 .
Auto reverse function
There are some small distances immediately before the closed position which cannot be detected. Make sure that all passengers have their hands, etc., inside the vehicle before closing the moonroof.
If the control unit detects something caught in the moonroof when it is closing, the moonroof will be immediately opened.
The auto reverse function can be activated when the moonroof is closed by automatic operation when the ignition switch is in the ON position or for about 45 seconds after the ignition switch is turned to the OFF position.
If the moonroof cannot be closed automatically
when the auto reverse function activates due to
a malfunction, push and hold the switch toward
2 .
Depending on the environment or driving conditions, the auto reverse function may be activated if an impact or load similar to something being caught in the moonroof occurs.
If the moonroof does not operate
If the moonroof does not operate properly, perform the following procedure to initialize the moonroof operation system.
1. If the moonroof is open, close it fully by
repeatedly pushing the switch toward
2 .
2. Push and hold the switch toward 2 to
tilt the moonroof up.
3. Release the moonroof switch after the moonroof moves slightly up and down.
4. Push and hold the switch toward
1 to
fully tilt the moonroof down.
5. Check if the moonroof switch operates normally.
If the moonroof does not operate properly after performing the procedure above, have your vehicle checked by a NISSAN dealer.
See also:
Fail-safe
If the vehicle is driven under extreme
conditions, such as excessive wheel spinning
and subsequent hard braking, the
fail-safe system may be activated. The MIL
may illuminate to indicate the f ...
Control buttons
Control buttons
The control buttons for the Bluetooth® Hands-
Free Phone System are located on the steering
wheel.
PHONE SEND
Push the button to initiate a VR
session or
answer an inco ...
Troubleshooting guide
Verify the location of all Intelligent Keys that are
programmed for the vehicle. If another Intelligent
Key is in range or inside the vehicle, the vehicle
system may respond differently than expect ...