Clearing the programmed information - HomeLink® Universal Transceiver (if so equipped) - Instruments and controls - Nissan Rogue Owners Manual - Nissan Rogue | Nissaguide.com

Clearing the programmed information

Nissan Rogue / Nissan Rogue Owners Manual / Instruments and controls / HomeLink® Universal Transceiver (if so equipped) / Clearing the programmed information

Individual buttons cannot be cleared, however to clear all programming, push and hold the two outside buttons and release when the indicator light begins to flash (in approximately 20 seconds).

See also:

Trunk light
The light illuminates when the trunk lid is opened. When the trunk lid is closed, the light goes off. For bulb replacement procedures, refer to “Exterior and interior lights” in the “Mainten ...

USB (Universal Serial Bus) devices (if so equipped)
This system supports various USB memory sticks, USB hard drives and iPod® players. There are some USB devices which may not be supported with this system. - Make sure that the USB device is con ...

Operating tips
● Say a command after the tone. Voice commands cannot be accepted when the icon is . ● Commands that are available are always shown on the display and spoken through voice menu prompt ...