Hood

(1) Pull the hood lock release handle located

(1) Pull the hood lock release handle located below the driver side instrument panel. The hood will spring up slightly.

 (2)- Push the lever at the front of the hood to the side as illustrated with your fingertips and raise the hood.

When closing the hood, lower it slowly and make sure it locks into place.

WARNING:

- Make sure the hood is completely closed and latched before driving. Failure to do so could cause the hood to fly open and result in an accident.

- If you see steam or smoke coming from the engine compartment, to avoid injury do not open the hood.

    See also:

    Trailer lights
    When splicing into the vehicle electrical system, a commercially available powertype module/converter must be used to provide power for all trailer lighting. This unit uses the vehicle bat ...

    Steering wheel switch for audio control (if so equipped)
    Type A 1. Tuning switch 2. MODE select switch 3. POWER on/off switch 4. Volume control switch Type B 1. Tuning switch 2. Phone operation switch 3. POWER on and MODE select switch 4. ...

    IC Regulatory information
    - Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause unde ...