Using the system
Initialization
When the ignition switch is placed in the ON
position, NISSAN Voice Recognition is initialized,
which takes a few seconds. When completed,
the system is ready to accept voice commands. If
the 
switch is pressed before
the initialization
completes, voice commands will not be accepted.
Please wait until the NISSAN Voice Recognition initialization is completed.
See also:
Keyfob (if so equipped)
Keyfob (if so equipped)
Replace the battery in the keyfob as follows.
1 Open the lid using a coin A .
2 Remove the battery B .
3 Install a new battery C with the “+” facing
down.
● ...
Clearing the programmed information
Individual buttons cannot be cleared, however to
clear all programming, push and hold the two
outside buttons and release when the indicator
light begins to flash (in approximately 20
seconds) ...
How to see each view
- The distance guide line and the
vehicle width line should be used
as a reference only when the vehicle
is on a paved, level surface. The
distance viewed on the monitor is
for reference ...