Headlights

Replacing the xenon headlight bulb (if so equipped)

HIGH VOLTAGE:

When xenon headlights are on, they produce a high voltage. To prevent an electric shock, never attempt to modify or disassemble.

Always have your xenon headlights replaced at a NISSAN dealer. For additional information, see Headlight and turn signal switch in the Instruments and controls section.

Replacing the halogen headlight bulb (if so equipped)

The headlight is a semi-sealed beam type which uses a replaceable headlight (halogen) bulb. Because the headlight assembly must be removed from the vehicle for bulb replacement, see your NISSAN dealer.

CAUTION:

- Aiming is not necessary after replacing the bulb. When aiming adjustment is necessary, contact a NISSAN dealer.

- Do not leave the headlight assembly open without a bulb installed for a long period of time. Dust, moisture, smoke, etc. entering the headlight body may affect bulb performance. Remove the bulb from the headlight assembly just before a replacement bulb is installed.

- Only touch the base when handling the bulb. Never touch the glass envelope.

Touching the glass could significantly affect bulb life and/or headlight performance.

- High pressure halogen gas is sealed inside the halogen bulb. The bulb may break if the glass envelope is scratched or the bulb is dropped.

Fog may temporarily form inside the lens of the exterior lights in the rain or in a car wash. A temperature difference between the inside and the outside of the lens causes the fog. This is not a malfunction. If large drops of water collect inside the lens, contact a NISSAN dealer.

    See also:

    How to select menus on the screen
    Vehicle functions are viewed on the center display screen in menus. Whenever a menu selection is made or menu item is highlighted, different areas on the screen provide you with important in ...

    Drive belt
    MR20DE model 1. Automatic tensioner 2. Generator 3. Water pump 4. Air conditioner compressor (with A/C) or Idler pulley (without A/C) 5. Crankshaft pulley QR25DE model 1. Crankshaft p ...

    Audio main operation
    Audio main operation AUX button: Place the ignition switch in the ACC or ON position and press the AUX button repeatedly until the iPod mode is displayed on the screen. If another audio sourc ...