If your vehicle overheats

- Do not continue to drive if your

- Do not continue to drive if your vehicle overheats. Doing so could cause engine damage or a vehicle fire.

- To avoid the danger of being scalded, never remove the radiator cap while the engine is still hot.

When the radiator cap is removed, pressurized hot water will spurt out, possibly causing serious injury.

- Do not open the hood if steam is coming out.

If your vehicle is overheating (indicated by an extremely high temperature gauge reading), or if you feel a lack of engine power, detect abnormal noise, etc., take the following steps:
1. Move the vehicle safely off the road, apply the parking brake and move the selector lever to the P (Park) position.

Do not stop the engine.

2. Turn off the air conditioner. Open all the windows, move the heater or air conditioner temperature control to maximum hot and fan control to high speed.

3. Get out of the vehicle. Look and listen for steam or coolant escaping from the radiator before opening the hood. (If steam or coolant is escaping, turn off the engine.) Do not open the hood further until no steam or coolant can be seen.

4. Open the engine hood.

If steam or water is coming from the

If steam or water is coming from the engine, stand clear to prevent getting burned.

5. Visually check drive belts for damage or looseness. Also check if the cooling fan is running. The radiator hoses and radiator should not leak water. If coolant is leaking, the water pump belt is missing or loose, or the cooling fan does not run, stop the engine.

Be careful not to allow your hands, hair,

Be careful not to allow your hands, hair, jewelry or clothing to come into contact with, or get caught in, engine belts or the engine cooling fan. The engine cooling fan can start at any time.

6. After the engine cools down, check the coolant level in the reservoir tank with the engine running. Add coolant to the reservoir tank if necessary. Have your vehicle repaired at a NISSAN dealer.

    See also:

    Continuously Variable Transmission (CVT) check warning light (if so equipped)
    When the ignition switch is placed in the ON position, the light comes on for about 2 seconds. If the light comes on at any other time, it may indicate the CVT system is not functioning properly. ...

    FM/AM/SAT radio operation
    FM/AM band select: Pressing the FM·AM button will change the band as follows: AM > FM1 > FM2 > AM When the FM·AM button is pressed while the ignition switch is in the ACC or ON position, the ...

    Waxing
    Regular waxing protects the paint surface and helps retain new vehicle appearance. Polishing is recommended to remove built-up wax residue and to avoid a weathered appearance before re-applyin ...