Trailer lights

When splicing into the vehicle electrical

When splicing into the vehicle electrical system, a commercially available power-type module/converter must be used to provide power for all trailer lighting. This unit uses the vehicle battery as a direct power source for all trailer lights while using the vehicle tail light, stoplight and turn signal circuits as a signal source. The module/converter must draw no more than 15 milliamps from the stop and tail lamp circuits. Using a module/converter that exceeds these power requirements may damage the vehicle’s electrical system.

See a reputable trailer dealer to obtain the proper equipment and to have it installed.

Trailer lights should comply with federal and/or local regulations. For assistance in hooking up trailer lights, contact a NISSAN dealer or reputable trailer dealer.

    See also:

    Voice command examples
    Some basic voice command examples are described here. For navigation system commands, see the separate Navigation System Owner’s Manual. Example 1 — Placing a call to the phone number 800-6 ...

    ON position
    When the switch is in the ON position 1 , the map lights will illuminate. ...

    Locking with power door lock switch
    Door lock switch To lock all the doors without a key, push the door lock switch (driver’s or front passenger’s side) to the lock position 1 . When locking the door this way, be certain not t ...