Pre-driving checks and adjustments

See also:

Headlight beam select
Headlight beam select 1 To select the low beam, put the lever in the neutral position as shown. 2 To select the high beam, push the lever forward while the switch is in the position. Pull it ...

Installing front license plate
Use the following steps to mount the front license plate: (1) Make holes on the plastic finisher at the location mark (small dimple) using a 0.31 in (8 mm) drill. Apply light pressure to the ...

Passenger compartment
CAUTION Never use a fuse of a higher or lower amperage rating than specified on the fuse box cover. This could damage the electrical system or cause a fire. If any electrical equipment does not ...