Hood
Hood
1. Pull the hood lock release handle 1 located below the instrument panel until the hood springs up slightly.
2. Locate the lever 2 in between the hood and grille and push the lever sideways with your fingertips.
3. Raise the hood 3 .
4. Remove the support rod 4 and insert it into the slot on the underside of the hood 5 .
When closing the hood, return the support rod to its original position, lower the hood to approximately 12 inches (30 cm) above the latch and release it. This allows proper engagement of the hood latch.
● Make sure the hood is completely closed and latched before driving. Failure to do so could cause the hood to fly open and result in an accident.
● If you see steam or smoke coming from the engine compartment, to avoid injury do not open the hood.
See also:
Compact Disc (CD) player operation
Place the ignition switch in the ACC or ON
position, and insert the CD into the slot with the
label side facing up. The CD will be guided
automatically into the slot and start playing.
After lo ...
EXTERIOR
From the windshield back, the Murano CrossCabriolet is every bit a sexy
convertible with a tail end that's reminiscent of its near relative, the Nissan
370Z. However, most people I polled weren't ...
Vents
Adjust air flow direction for the driver’s and passenger’s
side 1 , and center 2 ventilators by
moving the ventilator slide and/or ventilator assemblies.
Open or close the ventilators 1 by ...