Audible reminder and warning when the engine stops
When the P position selecting warning light
( 
) in the
instrument panel blinks in red.
● Make sure the shift selector is in the P (Park) position.
When the chime sounds intermittently.
● Make sure the shift selector is in the P (Park) position and the ignition switch is placed in the LOCK position.
If the chime sounds continuously when the driver’s door is opened, check the following.
● The shift selector is placed in the P (Park) position and the ignition switch is placed in the LOCK position.
● The mechanical key is not inserted into the ignition switch.
● The warning chime may stop when one of the following is performed.
– Returning the ignition switch to the LOCK position.
– Removing the mechanical key.
– Closing the doors.
See also:
How to read the displayed lines
Without Navigation System
Lines which indicate the vehicle clearance and
distances to objects with reference to the bumper
line A are displayed on the monitor.
They are indicated as reference ...
Clearing the programmed information
Individual buttons cannot be cleared. However,
to clear all programming, press and hold the two
outside buttons and release when the indicator
light begins to flash (approximately 20 seconds). ...
Vehicle Dynamic Control (VDC) system (if so
equipped)
The Vehicle Dynamic Control (VDC) system uses
various sensors to monitor driver inputs and vehicle
motion. Under certain driving conditions,
the VDC System helps to perform the following
funct ...