Heating

This mode is used to direct heated air to the foot outlets. Some air also flows from the defrost outlets and outboard vents.

1. Push the normal heating. button to the off position for normal heating.

2. Turn the air flow control dial to the position. position.

3. Turn the fan control dial to the desired position.

4. Turn the temperature control dial to the desired position between the middle and the hot position.

    See also:

    Using the panic alarm (if so equipped)
    Using the panic alarm (if so equipped) If you are near your vehicle and feel threatened, you may activate the panic alarm to call attention by pressing and holding the button on the keyfob ...

    Operating tips
    ● Say a command after the tone. Voice commands cannot be accepted when the icon is . ● If the command is not recognized, the system repeats the announcement. Repeat the command in a c ...

    Call volume
    Adjusting the incoming or outgoing call volume may improve clarity if reception between callers is unclear. - Incoming calladjusting this setting allows you to hear a difference in volume. - ...