Audio main operation
POWER/VOLUME control:
Place the ignition switch in the ACC or ON position. Press the PWR button while the system is off to call up the mode (radio, CD or AUX) that was playing immediately before the system was turned off. While the system is on, pressing the PWR button turns the system off.
Turn the VOL control knob to adjust the volume.
MENU button (Bass, Treble, Fade, Balance and Clock):
Press the MENU button to change the mode as follows.
BAS (Bass) → TRE (Treble) → FAD (Fade) → BAL (Balance) → Clock → Normal mode
Press the SEEK or
or TUNE
or
button to adjust the Bass, Treble, Fade
and Balance to the desired level. Fade adjusts
the sound level between the front and rear speakers
and Balance adjusts the sound between the
right and left speakers.
Once you have adjusted the sound quality to the desired level, press the MENU button repeatedly until the radio or CD display reappears. If no action is taken, the radio or CD display will automatically reappear after approximately 10 seconds.
Clock set
If the clock is not displayed with the ignition switch in the ACC or ON position, you need to select the CLK-ON mode. Press the MENU button repeatedly until CLK-OFF mode is displayed.
Use the TUNE/FF-REW/FOLDER button to enable CLK-ON mode.
1. Press the MENU button repeatedly until “Clock:” appears. The hours will begin flashing.
2. Press the SEEK button
or
or
the TUNE button
or
to adjust
the hours.
3. Press the MENU button again. The minutes will begin flashing.
4. Press the SEEK button or
or
the TUNE button
or
to adjust
the minutes.
5. Press the MENU button again to exit the clock set mode.
If no action is taken, the display will return to the regular clock display after 10 seconds.
See also:
Summer tires
NISSAN specifies summer tires on some models
to provide superior performance on dry roads.
Summer tire performance is substantially reduced
in snow and ice. Summer tires do not have
the tire tr ...
Off-road recovery
If the right side or left side wheels leave the road
surface, maintain control of the vehicle by
following the procedure below. Please note that
this procedure is only a general guide. The
veh ...
Engine serial number
The number is stamped on the engine as shown. ...