Windshield wiper and washer switch

In freezing temperatures the washer

In freezing temperatures the washer solution may freeze on the windshield and obscure your vision which may lead to an accident. Warm windshield with the defroster before you wash the windshield.

- Do not operate the washer continuously

- Do not operate the washer continuously for more than 30 seconds.

- Do not operate the washer if the reservoir tank is empty.

- Do not fill the window washer reservoir tank with washer fluid concentrates at full strength. Some methyl alcohol based washer fluid concentrates may permanently stain the grille if spilled while filling the window washer reservoir tank.

- Pre-mix washer fluid concentrates with water to the manufacturer’s recommended levels before pouring the fluid into the window washer reservoir tank. Do not use the window washer reservoir tank to mix the washer fluid concentrate and water.

If the windshield wiper operation is interrupted by snow or ice, the wiper may stop moving to protect its motor. If this occurs, turn the wiper switch to the OFF position and remove the snow or ice that is on and around the wiper arms. In approximately 1 minute, turn the switch on again to operate the wiper.

The windshield wiper and washer operates

The windshield wiper and washer operates when the ignition switch is in the ON position.

Push the lever down to operate the wiper at the following speed:
1 Intermittent — intermittent operation can be adjusted by turning the knob toward A (Slower) or B (Faster).

2 Low — continuous low speed operation
3 High — continuous high speed operation
Push the lever up 4 to have one sweep operation of the wiper.

Pull the lever toward you 5 to operate the washer. Then the wiper will also operate several times.

    See also:

    Locking with key
    Locking with key The power door lock system allows you to lock or unlock all doors simultaneously. - Turning the driver’s door key cylinder to the front of the vehicle 1 will lock all doors ...

    Lighting
    1 Turn the switch to the position: The front park, side marker, tail, license plate and instrument lights will come on. 2 Turn the switch to the position: Headlights will come on and all the ...

    Releasing the trunk lid
    Press the button for longer than 0.5 seconds to open the trunk lid. The trunk release button will not operate when the ignition switch is in the ON position or when the trunk cancel switch is ...