Rear window wiper and washer switch

In freezing temperatures the washer

In freezing temperatures the washer solution may freeze on the rear window glass and obscure your vision. Warm the rear window with the defroster before you wash the rear window.

- Do not operate the washer continuously

- Do not operate the washer continuously for more than 30 seconds.

- Do not operate the washer if the reservoir tank is empty.

- Do not fill the window washer reservoir tank with washer fluid concentrates at full strength. Some methyl alcohol based washer fluid concentrates may permanently stain the grille if spilled while filling the window washer reservoir tank.

- Pre-mix washer fluid concentrates with water to the manufacturer’s recommended levels before pouring the fluid into the window washer reservoir tank. Do not use the window washer reservoir tank to mix the washer fluid concentrate and water.

If the rear window wiper operation is interrupted by snow or ice, the wiper may stop moving to protect its motor. If this occurs, turn the wiper switch to the OFF position and remove the snow or ice that is on and around the wiper arms. In approximately 1 minute, turn the switch on again to operate the wiper.

The rear window wiper and washer operate

The rear window wiper and washer operate when the ignition switch is in the ON position.

Turn the switch clockwise from the OFF position to operate the wiper.

1 Intermittent (INT) — intermittent operation (not adjustable)
2 Low (ON) — continuous low speed operation
Push the switch forward 3 to operate the washer. Then the wiper will also operate several times.

    See also:

    Starting the vehicle
    1. After starting the engine, fully depress the foot brake pedal before moving the shift selector out of the P (Park) position. 2. Keep the foot brake pedal depressed and move the shift selecto ...

    Fuel gauge
    The gauge indicates the approximate fuel level in the tank. The gauge may move slightly during braking, turning, acceleration, or going up or down hills. The gauge needle returns to E (Empty) af ...

    Controls
    Outside air circulation: Push the air recirculation button to turn off the indicator light on the button. The air flow is drawn from outside the vehicle. Air recirculation: Push the air recircu ...