Audio main operation

Head unit:

The auto loudness circuit enhances the low and high frequency ranges automatically in both radio reception and CD playback.

ON·OFF/Volume control:

Place the ignition switch in the ACC or ON position, and then push the PWR button while the system is off to call up the normal mode (radio, CD, AUX and iPod®) which was playing immediately before the system was turned off.

While the system is on, pushing the PWR button turns the system off.

Turn the VOL control knob to adjust the volume.

MUTE button:

MUTE button:

Push the audio sound. button to mute the audio sound.

Push the the mute setting. button again to release the mute setting.

AUDIO button:

AUDIO button:

Push the AUDIO button to change the selecting mode as follows.

Push the TUNE ( ,

Push the TUNE () or SEEK ( , , )) or SEEK (, ) , button to adjust Bass and Treble to the desired) button to adjust Bass and Treble to the desired level. Use the TUNE or SEEK button also to adjust Fade or Balance modes. Fade adjusts the sound level between the front and rear speakers and Balance adjusts the sound between the right and left speakers.

To turn the beep sound off or on, push the TUNE or SEEK button until the desired mode is displayed. This turns on or off the beep sound when audio buttons are pushed.

To change the Speed Sensitive Volume (Spd Sen Vol) mode to OFF, LOW, MID or HIGH, push the TUNE or SEEK button until the desired mode is displayed.

Once you have adjusted the sound quality to the desired level, push the AUDIO button repeatedly until the normal mode display reappears. Otherwise, the normal mode display will automatically reappear after approximately 5 seconds.

CLOCK button:

CLOCK button:

Push the CLOCK button to turn on or off the CLOCK display.

Push the CLOCK button 1 to turn the clock on

Push the CLOCK button 1 to turn the clock on or off.

1. Push and hold the CLOCK button 1 until the clock display starts to flash.

2. Push the SEEK/TRACK button 2 to adjust the hours.

3. Push the TUNE/FF·REW button 3 to adjust the minutes.

4. Push the CLOCK button 1 again to exit the clock set mode.

The display will return to the regular clock display after 5 seconds.

    See also:

    Operating range
    Coupe shown Sedan similar The Intelligent Key functions can only be used when the Intelligent Key is within the specified operating range from the request switch 1 . When the Intelligent Key bat ...

    Tongue load
    When using a weight carrying or a weight distributing hitch, keep the tongue load between 10 to 15% of the total trailer load within the maximum tongue load limits shown in the following â ...

    Owner’s Manual/Service Manual order information
    A genuine NISSAN Service Manual is the best source of service and repair information for your vehicle. Filled with wiring diagrams, illustrations and step-by-step diagnostic and adjustment proce ...