FM-AM-SAT radio operation

When the radio band select button is pushed while the ignition switch is in the ACC or ON position, the radio will come on at the channel last played.

The last channel played will also come on when the ON·OFF button is pushed to ON.

If another audio source is playing when the radio band select button is turned to ON, the audio source will automatically be turned off and the last radio channel played will come on.

When the stereo broadcast signal is weak, the radio will automatically change from stereo to monaural reception.

FM·AM radio band select:

FM·AM radio band select:

Pushing the FM·AM radio band select button will change the band as follows:
AM FM2 FM1 AM FM2 AM

XM radio band select:

XM radio band select:

Pushing the XM radio band select button will change the band as follows:
XM1 XM3 XM2 XM1 XM3 The satellite radio is not available in Alaska, XM1
The satellite radio is not available in Alaska, Hawaii and Guam.

TUNE (Tuning):

- For AM and FM radio
Turn the TUNE knob for manual tuning.

- For XM Satellite Radio
Turn the TUNE knob to seek channels from all of the categories when any category is not selected.

SEEK tuning:

SEEK tuning:

- For AM and FM radio
Push the SEEK/CATEGORY button or to tune from low to high or high to low to tune from low to high or high to low frequencies and to stop at the next broadcasting station.

- For XM Satellite Radio
Push the SEEK/CATEGORY button or to tune to the first channel of the next or to tune to the first channel of the next or previous category.

Tuning with the touchscreen (AM and FM radio):

When in AM or FM mode, the radio can be tuned using the touchscreen. To bring up the visual tuner, touch the “Tune” key on the lower right corner of the screen. A screen appears with a bar running from low frequencies on the left to high frequencies on the right. Touch the screen at the location of the frequency you wish to tune and the station will change to that frequency. To return to the regular radio display screen, touch the “OK” key.

1 to 6 Station memory operations:

12 stations/channels can be set for the FM band (6 each for FM1 and FM2), 18 for XM radio (6 each for XM1, XM2 and XM3) and 6 stations can be set for the AM band.

1. Choose the radio band using the radio band select button.

2. Tune to the desired station/channel using the SEEK/CATEGORY button or the TUNE knob.

3. Push and hold the desired station preset button 1 to 6 until the beep sound is heard.

4. The station indicator will then come on and the sound will resume. Memorizing is now complete.

5. Other buttons can be set in the same manner.

If the battery cable is disconnected, or if the fuse opens, the radio memory will be erased. In that case, reset the desired stations/channels.

Touchscreen (XM Satellite Radio):

When the XM Satellite Radio is being played, the following items are available with the touchscreen operation.

- Channels
Displays a list of channels. Touch a preferred channel displayed on the list to change to that channel.

- Categories
Displays a list of categories. Touch a preferred channel displayed on the list to display options within that category.

    See also:

    Giving voice command
    To operate NISSAN Voice Recognition, push and release the button located on the steering wheel. After the tone sounds, speak a command. The command given is picked up by the microphone, an ...

    A Cube With a View
    The Cube is a few inches narrower than its boxy competitors, but it has plenty of headroom. Proving again that dimensions don't tell the whole story, the Cube's front seat could use a little more ...

    NISSAN dealer.
    However, now and then you may notice light spark knock for a short time while accelerating or driving up hills. This is not a cause for concern, because you get the greatest fuel benefit when ther ...