Operating tips

-When the engine coolant temperature and

-When the engine coolant temperature and outside air temperature are low, the air flow from the foot outlets may not operate for a maximum of 150 seconds. However, this is not a malfunction. After the coolant temperature warms up, air flow from the foot outlets will operate normally.

The sunload sensor, located on the top drivers side of the instrument panel, helps the system maintain a constant temperature. Do not put anything on or around this sensor.

    See also:

    Heater operation
    Heating: This mode is used to direct heated air to the foot outlets. 1. Push the air recirculation button to the OFF position. (The indicator light turns off.) 2. Turn the air flow control ...

    Reporting safety defects
    For USA If you believe that your vehicle has a defect which could cause a crash or could cause injury or death, you should immediately inform the National Highway Traffic Safety Administratio ...

    Off-road recovery
    If the right side or left side wheels unintentionally leave the road surface, maintain control of the vehicle by following the procedure below. Please note that this procedure is only a general ...