CD care and cleaning

-Handle a CD by its edges. Do not bend the

-Handle a CD by its edges. Do not bend the disc. Never touch the surface of the disc.

- Always place the discs in the storage case when they are not being used.

- To clean a disc, wipe the surface from the center to the outer edge using a clean, soft cloth. Do not wipe the disc using a circular motion.

- Do not use a conventional record cleaner or alcohol intended for industrial use.

- A new disc may be rough on the inner and outer edges. Remove the rough edges by rubbing the inner and outer edges with the side of a pen or pencil as illustrated.

Type A
Type A

1. Power on and SOURCE select switch.

2. Tuning switch.

3. Volume control switch.

Type B
Type B

1. Power on and SOURCE select switch.

2. Menu control switch/ENTER button.

3. Volume control switch.

    See also:

    Off-road recovery
    If the right side or left side wheels unintentionally leave the road surface, maintain control of the vehicle by following the procedure below. Please note that this procedure is only a general ...

    Operating tips (for automatic air conditioner)
    When the engine coolant temperature and outside air temperature are low, the air flow from the foot outlets may not operate for a maximum of 150 seconds. However, this is not a malfunction. Af ...

    Styling & Interior
    The Rogue's styling had been a bit anonymous, but a few exterior changes — more creases up front, extra chrome along the doors and grille — add some character. The silhouette remains the same, ...