Seat belts
The seat belts can be cleaned by wiping them with a sponge dampened in a mild soap solution.
Allow the belts to dry completely in the shade before using them. See Seat belt maintenance in the Safety Seats, seat belts and supplemental restraint system section of this manual.
WARNING:
Do not allow wet seat belts to roll up in the retractor. NEVER use bleach, dye or chemical solvents to clean the seat belts, since these materials may severely weaken the seat belt webbing.
See also:
Trunk lid release
Driver’s side
The trunk lid release is located on the floor to the
left of the driver’s seat. To open the trunk lid, pull
the trunk lid release.
To close the trunk lid, lower and push the ...
Emergency engine shut off
To shut off the engine in an emergency situation
while driving perform the following procedure:
– Rapidly push the push-button ignition switch 3
consecutive times, or
– Push and hold the push- ...
Freeing a frozen door lock
To prevent a door lock from freezing, apply deicer
through the key hole. If the lock becomes
frozen, heat the key before inserting it into the key
hole, or use the remote keyless entry keyfob (i ...