Installing top tether strap

First, secure the child restraint with the LATCH

First, secure the child restraint with the LATCH lower anchors (rear outboard seat positions only) or the seat belt, as applicable.

1. Flip up the anchor cover 1 from the anchor point which is located directly behind the child seat.
2. Position the top tether strap over the top of the seatback 2 .> 3. Secure the tether strap to the tether anchor point on the rear parcel shelf 3 .> 4. Refer to the appropriate child restraint installation procedure steps in this section before tightening the tether strap.

To remove or reinstall the tether anchor covers, see “Upper tether anchor/key cylinder covers” in the “Maintenance and do-it-yourself” section of this manual.

If you have any questions when installing a top tether strap, consult your NISSAN dealer for details.

    See also:

    SPORT mode switch
    SPORT mode switch In the SPORT mode, the engine and transmission are controlled to set the engine speed higher than in the D (Drive) position. This enhances throttle response for a “sport ...

    Sway control device
    Sudden maneuvers, wind gusts, and buffeting caused by other vehicles can affect trailer handling. Sway control devices may be used to help control these affects. If you choose to use one, contact ...

    Changing engine coolant
    A NISSAN dealer can change the engine coolant. The service procedure can be found in the NISSAN Service Manual. Improper servicing can result in reduced heater performance and engine overheating. ...