Warning signals

To help prevent the vehicle from moving unexpectedly by erroneous operation of the Intelligent Key or to help prevent the vehicle from being stolen, a chime or buzzer sounds from inside and outside the vehicle and a warning is displayed in the instrument panel.

When a chime or beep sounds or a warning is displayed, be sure to check the vehicle and the Intelligent Key.

See the “Troubleshooting guide” that follows and “Vehicle information display” in the “Instruments and controls” section of this manual.

    See also:

    Around viewTM monitor (if equipped)
    The CAMERA button is located on the center console. When you push the CAMERA button or shift the selector lever into the “R” (Reverse) position while the ignition switch is in the ON posi ...

    g (gravity)-force gauge (if so equipped)
    g (gravity)-FORCE GAUGE (if so equipped) This gauge shows the straight-line acceleration and deceleration g-forces while you are driving. NOTE: The g-force gauge does not indicate cornering ...

    Loading tips
    ● The GVW must not exceed GVWR or GAWR as specified on the F.M.V.S.S./C.M.V.S.S. certification label. ● Do not load the front and rear axle to the GAWR. Doing so will exceed the GVWR ...