Glass
When cleaning the rear window, it may be easier to clean if the high-mounted stop light (if so equipped) is removed first.
Be careful when removing the high-mounted stop light to reduce the risk of damaging the high-mounted stop light wires.
To remove the high-mounted stop light:
1 Push toward rear of vehicle.
2 Lift to remove.
The high-mounted stop light must be properly reinstalled before driving your vehicle.
Use glass cleaner to remove smoke and dust film from the glass surfaces. It is normal for glass to become coated with a film after the vehicle is parked in the hot sun. Glass cleaner and a soft cloth will easily remove this film.
CAUTION
When cleaning the inside of the windows, do not use sharp-edged tools, abrasive cleaners or chlorine-based disinfectant cleaners. They could damage the electrical conductors, radio antenna elements or rear window defroster elements.
See also:
Tire labeling
Example
Federal law requires tire manufacturers to
place standardized information on the sidewall
of all tires. This information identifies
and describes the fundamental characteristics
of ...
Installing front license plate
Use the following steps to mount the front license
plate:
(1) Make holes on the plastic finisher at the
location mark (small dimple) using a 0.31 in
(8 mm) drill. Apply light pressure to the ...
How to park with predicted course lines
WARNING:
- Always turn and check that it is safe to
do so before backing up. Always back
up slowly.
- Use the displayed lines as a reference.
The lines are highly affected by the
number of oc ...