Replacing

1. Lift the wiper arm away from the windshield.

1. Lift the wiper arm away from the windshield.
2 Push the release tab, then move the wiper blade down the wiper arm to remove.
3 Remove the wiper blade.
4. Insert the new wiper blade onto the wiper arm until it clicks into place.
5. Rotate wiper blade so the dimple is in the groove.
6. Return the wiper to its original position and release it until it has made contact with the windshield.

CAUTION

● After wiper blade replacement, return the wiper arm to its original position; otherwise it may be damaged when the hood is opened.
● Make sure the wiper blades contact the glass; otherwise the arms may be damaged from wind pressure.

If you wax the surface of the hood, be careful not

If you wax the surface of the hood, be careful not to let wax get into the windshield washer nozzle A . This may cause clogging or improper windshield washer operation. If wax gets into the nozzle, remove it with a needle or small pin B .

    See also:

    Capacities and recommended fuel/lubricants
    The following are approximate capacities. The actual refill capacities may be slightly different. When refilling, follow the procedure described in the “Maintenance and do-it-yourself” section ...

    Explanation of general maintenance items
    Additional information on the following items with “ * ”is found later in this section. Outside the vehicle The maintenance items listed here should be performed from time to time, unless othe ...

    Adjustment
    Adjust the head restraint so the center is level with the center of the seat occupant’s ears. To raise the head restraint, pull it up. To lower, push and hold the lock knob and push the he ...