Power outlet

Instrument panel
Instrument panel

The power outlets are for powering electrical accessories such as cellular telephones. They are rated at 12 Volt, 120W (10A) maximum.

The power outlet located on the bottom center portion of the instrument panel is powered directly by the vehicle’s battery. The power outlet located in the console (if so equipped) is powered only when the ignition switch is placed in the ACC or ON position.

Console (if so equipped)
Console (if so equipped)

● The outlet and plug may be hot during

● The outlet and plug may be hot during or immediately after use.

● The power outlets are not designed for use with a cigarette lighter.

● Do not use with accessories that exceed a 12 volt, 120W (10A) power draw.

Do not use double adapters or more than one electrical accessory.

● Use power outlets with the engine running to avoid discharging the vehicle battery.

● Avoid using power outlets when the air conditioner (if so equipped), headlights or rear window defroster is on.

● Before inserting or disconnecting a plug, be sure the electrical accessory being used is turned OFF.

● Push the plug in as far as it will go. If good contact is not made, the plug may overheat or the internal temperature fuse may open.

● When not in use, be sure to close the cap. Do not allow water or any other liquid to contact the outlet.

    See also:

    How to use the STATUS button
    To display the status of the audio, climate control system and fuel consumption, press the STATUS button. The following information will appear when the STATUS button is pressed multiple times: ...

    Moving closer to a projecting object
    The position C is shown further than the position B in the display. However, the position C is actually at the same distance as the position A . The vehicle may hit the object when moving to ...

    Forward-facing child restraint installation using the seat belts
    The three-point seat belt with Automatic Locking Retractor (ALR) must be used when installing a child restraint. Failure to use the ALR mode will result in the child restraint not being prop ...