Audio main operation
POWER/VOLUME control:
Place the ignition switch in the ACC or ON position. Press the PWR button while the system is off to call up the mode (radio, CD or AUX) that was playing immediately before the system was turned off. While the system is on, pressing the PWR button turns the system off.
Turn the VOL control knob to adjust the volume.
MUTE button:
Press the button to mute the audio sound.
Press the button again to resume playing the audio at its previous volume.
AUDIO button (Bass, Treble, Fade, Balance, SSV, Beep):
Press the AUDIO button to change the mode as follows.
Bass → Treble → Fade → Balance → Speed Sensitive Volume (SSV) → Beep ON/OFF → Normal mode To adjust Bass, Treble, Fade and Balance, press the AUDIO button until the desired mode appears in the display. Press the TUNE or or SEEK or button to adjust the selected mode to the desired level. Fade adjusts the sound level between the front and rear speakers and Balance adjusts the sound between the right and left speakers.
To change the Beep to ON or OFF, press the TUNE button up or down until the desired mode is displayed. This will enable or disable the beep sound heard during menu selection.
]To change the Speed Sensitive Volume (SSV) mode to OFF, LOW, MID or HIGH, press the TUNE button or until the desired setting is displayed.
Once you have adjusted the sound quality to the desired level, press the AUDIO button repeatedly until the radio or CD display reappears. If no action is taken, the radio or CD display will automatically reappear after approximately 5 seconds.
Clock set
If the clock is not displayed with the ignition switch in the ACC or ON position, you need to select the CLK-ON mode. Press the MENU button repeatedly until CLK-OFF mode is displayed.
Use the TUNE/FF-REW/FOLDER button to enable CLK-ON mode.
1. Press and hold the CLOCK button until the clock display starts to flash.
2. Press the SEEK/TRACK button or to adjust the hours.
3. Press the TUNE/FF-REW/FOLDER button or to adjust the minutes.
4. Press the CLOCK button again to exit the clock set mode.
If no action is taken, the display will return to the regular clock display after 10 seconds.
DISP (display) button
This button works during FM, CD and iPod operation. See the detailed function for this button in the section for each mode.
iPOD MENU, ENTER and BACK buttons
These buttons can only be used for iPod operations.
See “iPod player operation without Navigation System (Type A)” in this section for details about the functions of these buttons.
See also:
Radio operation
Radio (FM/AM) band select:
Pushing the FM·AM radio band select button will
change the band as follows:
AM FM1
FM2
AM
When the stereo broadcast signal is weak, the
radio will automatical ...
During a call
There are some options available during a call.
Select one of the following displayed on the
screen, if necessary:
Hang up:
Finish the call.
Use Handset:
Transfer the call to the cellular phon ...
Doors
When the doors are locked using one of the
following methods, the doors can not be opened
using the inside or outside door handles. The
doors must be unlocked to open the doors.
WARNING
● A ...