Connecting iPod

To connect an iPod to the vehicle so that the iPod can be controlled with the audio system controls and display screen, use the USB jack located in the center console. Open the protective cover on the USB jack in the center console and then connect the iPod -specific end of the cable to the iPod and the USB end of the cable to the USB jack on the vehicle 1 . If your iPod supports charging via a USB connection, its battery will be charged while connected to the vehicle with the ignition switch in the ACC or ON position.

While connected to the vehicle, the iPod can only be operated by the vehicle audio controls.

To disconnect the iPod from the vehicle, remove the USB end of the cable from the USB jack on the vehicle, then remove the cable from the iPod .

* iPod is a trademark of Apple Inc., registered in the U.S. and other countries.

    See also:

    F.M.V.S.S./C.M.V.S.S. certification label
    The Federal/Canadian Motor Vehicle Safety Standard (F.M.V.S.S./C.M.V.S.S.) certification label is affixed as shown. This label contains valuable vehicle information, such as: Gross Vehicle W ...

    General maintenance
    During the normal day-to-day operation of the vehicle, general maintenance should be performed regularly as prescribed in this section. If you detect any unusual sounds, vibrations or smells, ...

    Rear-facing child restraint installation using LATCH
    Refer to all Warnings and Cautions in the “Child Safety” and “Child Restraint” sections before installing a child restraint. Follow these steps to install a rear-facing child restraint u ...